Avaya X330W-2DS1, User Manual, Page: 149 / 176

WAN CLI Commands
Avaya X330W-2DS1 User’s Guide 127
Note: After setting the controller’s mode, this command will:
1. Perform the
copy running-config startup-config
command.
2. Erase startup-config.
3. Reset the device.
The syntax for this command is:
ds-mode [e1
|
t1]
Output Example:
X330WAN-2DS1-1(configure)# ds-mode e1
Your startup-config file will be erased!
Your telnet session will be disconnected.
This operation may take a few minutes
The WAN module will reset, in order to make the required
change.
Do you want to continue (Y/N)?
Note: If this command is entered when the correct mode is selected (for example,
entering
ds1-mode e1
when the device is already in E1 mode) no errors are
generated.
duplex (FastEthernet interface context)
Use the
duplex
command to control the duplex setting for the interface.
The syntax for this command is:
duplex {full|half}
e1 Sets the device in E1 mode. All controllers are set to operate as E1.
t1 Sets the device in T1 mode. All controllers are set to operate as T1.
This is the default.
full Full duplex
half Halp duplex