Avaya X330W-2DS1, User Manual, Page: 137 / 176

Policy CLI Commands
Avaya X330W-2DS1 User’s Guide 115
[<access-list-index>
Examples:
X330WAN-2DS1-1(configure)# no ip distribution access-list 1
X330WAN-2DS1-1(configure)# no ip distribution access-list 2 25
Note: If a list index is not given the
no ip distribution access-list
, all
rules will be deleted.
set qos policy-source
Use the
set qos policy-source
command to set the policy source. The default
policy source is policy-server.
Note: Before configuring the IP access list, you must change the policy source mode
to local.
The syntax for this command is:
set qos policy-source
<source>
Example:
X330WAN-2DS1-1(configure)#
set qos policy-source local
show ip access-group
Use the
show ip access-group
command to display information about the
configured active access groups.
The syntax for this command for the X330WAN is:
show ip access-group <interface name>
[<directions>]
access-list-number An integer (1..99)
access-list-index An integer
source local | policy-server