Avaya X330W-2DS1, User Manual, Page: 136 / 176

Chapter 7 X330WAN CLI Commands
114 Avaya X330W-2DS1 User’s Guide
Example:
X330WAN-2DS1-1(config-if:FastEthernet1)# ip simulate 100 in
192.67.85.12 193.76.54.25
no ip composite-op
Use the
no ip composite-op
command to delete a composite operation from a
policy list.
Note: This command is only supported by the X330WAN module.
The syntax for this command is:
no ip composite-op monitor <policy-list-number> <composite-
operation-index>
Example:
X330WAN-2DS1-1(configure)# no ip composite-op 101 15
no ip distribution access-list
Use the
no ip distribution access-list
command to delete a distribution
list statement.
Note: This command is only supported by the X330WAN module.
The syntax for this command is:
no ip distribution access-list <access-list-number>
source port An integer (1..65535)
destination port An integer (1..65535)
established Value of TCP established bit
policy-list-number An integer (100..149), where 0 is the default
list.
composite-operation-index Index of operation in the table to be deleted.
Indices 0 - 12 can not be deleted.