[update-dscp <0 - 63>] [update-1p <0 - 7>] [set-drop-prec {high
drop | low drop}] [block <block_name>]
Variable Definitions
Variable
Value
name <name>
Specifies the name assigned to this access list.
addr-type <addrtype>
Specifies the IP address type to use for the access list.
src-ip <source_ip>
Specifies the source IP address to use for this access list.
dst-ip <destination_ip>
Specifies the destination IP address to use for this access list.
ds-field <dscp>
Specifies the DSCP value to use for this access list.
{protocol <protocol_type>
| next_header <header>}
Specifies the protocol type or IP header to use with this access
list.
src-port-min <port> src-
port-max <port>
Specifies the minimum and maximum source ports to use with
this access list. Both values must be specified.
dst-port-min <port> dst-
port-max <port>
Specifies the minimum and maximum destination ports to use
with the access list. Both values must be specified.
flow-id <flowid>
Specifies the flow ID to use with this access list.
drop-action {drop | pass}
Specifies the drop action to use for this access list.
update-dscp <0 - 63>
Specifies the DSCP value to update for this access list.
update-1p <0 - 7>
Specifies the 802.1p value to update for this access list.
set-drop-prec {high drop |
low drop}
Specifies the drop precedence to configure for this access list.
block <block_name>
Specifies the block name to associate with the access list.
Removing an IP access list
About this task
Remove an IP access list by performing this procedure.
Procedure
Remove an access list by using the following command from Global Configuration
mode.
no qos ip-acl <aclid>
ACLI reference for wired networks
Avaya WLAN 8100 CLI Reference
August 2013 307