Enhanced download command
You can update either active image or non-active image. Once the image download is done,
the unit resets and restarts with the new image regardless of the value of the Next Boot image
indicator. In case of image download without reset, the new image in the flash will be the Next
Boot image.
Use the
download
command to specify the download target image. The syntax for this
command is:
download [address <a.b.c.d>] {primary | secondary} {image <image
name> | image-if-newer <image name> | diag <image name>} [no-reset]
[usb]
The following table defines the parameters for the
download
command.
Table 34: download command parameters
Parameters
Variable
a.b.c.d
Specifies the IP address of the TFTP server
primary | secondary
Choose which image to download.
image <image name>
Download the specified image.
image-if-newer <image name>
Only download the image if the version is newer
than the installed version.
diag <image name>
Download the specified diagnostic image.
no-reset
Do not reset the switch after downloading.
usb
Download the image from the USB drive.
Note:
Dual Agent supports the WLAN switches NBUs through AAUR.
toggle next boot image command
You can use CLI commands to change the next boot image of the device.
Use the toggle-next-boot-image command to toggle the next boot image.
The syntax for this command is:
toggle-next-boot-image
You must restart the switch after this command to use the next boot image as the new primary
image.
boot secondary command
You can use CLI commands to change the next boot image of the device.
Use the boot secondary command to use the secondary boot image. The syntax for this
command is:
ACLI Reference for wired networks
184 Avaya WLAN 8100 CLI Reference
August 2013