Avaya W310, Command Reference Manual

Page: 330 / 440

Chapter 12 Wireless Authentication and Security Commands
314 Avaya W310 Command Reference Guide
security-mode
User level: privileged, supervisor.
Command Mode: SSID
Use the
security-mode
command to configure the security mode type for the wireless
network (SSID). If you do not specify a mode, the current security mode for the wireless
network is displayed. Use the [no] form of this command to reset the security mode to its
default value (none).
Syntax:
The syntax for this command is:
[no] security-mode {none | dot1x | wep | wpa-psk | wpa}
Example:
Syntax Description
{none | dot1x | wep |
wpa | wpa-psk} Configure the security mode for one of the following:
•
none - no security. This is the default entry.
• dot1x - 802.1x security
• wpa - WiFi Protected Access (WPA) that calls for 802.1x
unique keys
• wpa-psk - WiFi Protected Access (WPA) that uses a pre-
shared key (PSK)
• wep - Wired Equivalent Privacy (WEP) encryption keys.
W310-1(super/SSID building1)# security-mode wep
Done!
W310-1(super/SSID building1)#