Avaya W310, Command Reference Manual, Page: 203 / 440

Chapter 10 W310 Policy Commands
Avaya W310 Command Reference Guide 187
destination-ip
User level: privileged, supervisor.
Command Mode: IP Rule Table
Use the
destination-ip
command to set the requested destination IP address for
packets to which the current IP rule applies.
Syntax:
The syntax for this command is:
[not] destination-ip {host <ip-address> | any | <ip-address>
<wildcard>}
Example:
To specify that rule 21 applies to all packets having destination IP address 135.64.104.102
Syntax Description
host • ip-address : IP address of a specific host.
• any : Current rule applies to any address
<ip-address> Requested destination IP address.
<wildcard> Range of IP addresses of the rule.
The zero bits in the wildcard correspond to bits in the IP address
that remain fixed. The one bits in the wildcard correspond to bits
in the IP address that can vary. Note that this is the opposite of
how bits are used in a netmask.
not Destination IP address of packets to which this rule is not
applied. The rule is applied to all destination IP addresses except
for those that you specify with
not
keyword.
W310-1(super/ACL 330/ip rule 21)# destination-ip host
135.64.104.102
Done!
W310-1(super/ACL 330/ip rule 21)#