Avaya programming and use, Installation And Use Manual, Page: 51 / 468

Installation
The T1 Module
2-19
Initial Configuration of the T1 Module
2
To configure and maintain a T1 module, you must use the PARTNER ACS R6.0 PC Administration
software. You cannot program a T1 module via System Programming from extensions 10 or 11.
For instructions on how to install and use PARTNER ACS R6.0 PC Administration, see the
PARTNER
®
ACS R6.0 PC Administration Getting Started.
To set up a T1 module in a PARTNER system:
1. Start PARTNER ACS R6.0 PC Administration.
a. Perform one of the following steps:
— Click on the Start menu, and select Programs>PARTNER ACS R6.0 PC
Administration>PC Administration. (This is the default location. If you chose to
save your files to an alternate location during installation, your path will be different.)
— If you created a Start menu short-cut, click on the Start menu, and select PC
Administration.
— If you created a desktop short-cut, double-click on the PC Administration icon on the
desktop.
The New Translation Creation dialog box appears.
b. Choose PARTNER ACS R6.0, and click the OK button.
The New Translation Creation Confirmation dialog box appears.
c. Click the OK button.
A new translation file for the PARTNER ACS R6.0 system appears in the workspace. All of
the defaults are selected in this file.
2. Connect to the PARTNER system. (See the online help or the PARTNER
®
ACS R6.0 PC
Administration Getting Started.)
3. Back up and retrieve the translations from the PARTNER system.
a. From the Administration menu, select Retrieve System Information.
The PARTNER System Information Retrieval dialog box appears
b. Make sure the Remote Backup check box is selected to copy the current system
translation from the PARTNER system to the Remote Access card.
c. Make sure the Retrieve System Translations check box is selected to copy the system
translation from the Remote Access card to your PC.
d. Click the Next button.
The Save As dialog box appears.
e. Select the file or enter a new name for the translation you are retrieving, and then click the
Save button.
The PARTNER System Information Retrieval status box appears, showing the status of
the retrieval. When the retrieval is complete, a message box appears.