Avaya programming and use, Installation And Use Manual, Page: 285 / 468

Programming & Using Telephone Features
Manual Signaling (F13XX or F13*XX)
8-47
■
Pressing a Manual Signaling button does not initiate an intercom call unless you lift the
handset or press
S
, press
i
, and then press the Manual Signaling button.
■
To respond to a signal, the target extension must place an intercom call to the person
signaling.
■
You can use the Manual Signaling button instead of dialing the two-digit extension number
required for these features: Call Coverage, Call Forwarding/Call Follow-Me, Message
Light On, Message Light Off, Station Lock, and Voice Mailbox Transfer.
■
To transfer a call to an extension for which you have a Manual Signaling button, press
&
before pressing the Manual Signaling button.
Programming
8
To program a Manual Signaling button:
1. Press
f00
.
2. Press a programmable button.
3. Press
f13
.
4. Dial the two-digit extension number of the target extension. Enter
*
before the extension
number if you want to use the button for voice signaling.
5. Program another button for this extension, or exit programming mode.
Using Manual Signaling
8
To beep the target extension, press the programmed button while the handset is in the cradle. The
extension beeps for as long as the button is pressed.
To ring or voice signal the target extension:
1. Lift the handset or press
S
.
2. Press
i
.
3. Press the programmed button.
To transfer a call to the target extension:
1. While active on the call, press
&
.
2. Press the programmed button.