Avaya programming and use, Installation And Use Manual, Page: 256 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Caller ID Features
8-18
■
You cannot screen a call if the Cell Phone Connect feature is active.
Programming
8
1. Press
f00ssc
at extension 10 or 11.
2. Enter the number of the extension to be programmed with the feature.
3. Press a programmable button with LEDs.
4. Press
f25
.
5. Program another extension, or exit programming mode.
Caller ID Features
8
Caller ID is available on system display telephones on all lines for which you subscribe to Caller
ID service. Caller ID information is the caller’s telephone number (and name, if available). When
active on a call, you automatically receive Caller ID information for the duration of the call. When
your extension is idle, you receive Caller ID information for the call you will be connected to when
you lift the handset.
The following Caller ID features can be implemented by individual telephone users:
■
Caller ID Inspect
■
Caller ID Call Logging and Dialing
■
Caller ID Name Display
You can use all these features while using Call Screening (F25).
In Release 4.0 and later systems, you receive both the caller’s number and name on a
two-line display telephone while the call is ringing. The TransTalk telephones only receive
either the caller’s number or the caller’s name, depending on the status of the Caller ID
Name Display feature.
Caller ID information is unavailable on T1 lines. The message “Direct In Dial” or “DID” is
displayed for incoming calls on T1 lines with Direct Inward Dialing (DID).