Avaya programming and use, Installation And Use Manual, Page: 254 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Call Screening (F25)—Release 3.0 or Later
8-16
Programming
8
To program a Call Pickup button:
1. Press
f00
.
2. Press a programmable button.
3. To specify the extension to be answered, press left
i
, followed by 6 and the two-digit
system extension number. For example, to answer a call ringing at extension 23, press left
i623
.
4. Program another button for this extension, or exit programming mode.
Using Call Pickup on a System Telephone
8
1. Lift the handset.
2. Press the programmed button, or press
i6
and the two-digit number of the extension
at which the call is ringing or parked.
Using Call Pickup on a Single-Line Telephone
8
1. Lift the handset.
You hear intercom dial tone.
2. Dial
6
plus the two-digit number of the extension at which the call is ringing or parked.
Call Screening (F25)—Release 3.0 or Later
8
Call Screening allows you to listen to a caller leaving a message in your mailbox. This feature
applies only if you have a voice messaging system and an MLS or PARTNER system telephone.
This feature is not available on tip/ring telephones.
SECURITY ALERT:
Use Station Lock (F21) to prevent misuse of this feature. If Station Lock is activated, Call
Screening does not work.
You must program Call Screening on a line button with LEDs by using Centralized Telephone
Programming. Once the button is programmed, the user can turn the feature on by pressing the
button. Calls are now screened until the user turns the feature off by pressing the button again.
When the feature is on, Call Screening begins once the voice mail system has answered the call.
While the call is being screened, the user is connected to the call in a listen-only mode on the
speakerphone. The user can hear both the outgoing announcement and the incoming caller
leaving the message.