Avaya programming and use, Installation And Use Manual, Page: 153 / 468

Programming System Options
Recall Timer Duration (#107)
4-55
Recall Timer Duration (#107)
4
Use this feature to change the length of the timed signal, or switchhook flash, generated by the
system Recall feature (as well as by the Recall option used in Auto Dial and Speed Dial
numbers). Recall sends this timed signal over the telephone line to the local telephone company or
PBX to which the system is connected. Typically, you use the Recall feature to access a PBX,
central office, or Centrex feature, such as Call Waiting. Your local telephone company can tell you
the correct setting—for most Centrex systems, the correct setting is 800 msec. (or 32).
Considerations
4
■
You should change the factory setting only under two conditions:
— If using the system Recall feature has no effect, lengthen the time.
— If the system is connected to a PBX or Centrex system and Recall drops calls, shorten the
time.
Programming
4
To change the duration of the Recall Timer signal:
1. Press
f00ss#107
at extension 10 or 11. A display
similar to the following appears:
Recall Timer Duration
18 450-msec
2. Enter a different Recall Timer setting by pressing
D
or
d
. For example, to
increase the Recall Timer setting to 750 msec., press
d
until a display similar to the
following appears:
Recall Timer Duration
30 750-msec
You also can enter the setting number directly. For example, to set the Recall Timer to 750
msec., press
30
.
Recall Timer settings run from 01 to 80 (25 to 2000 msec. in 25 msec. increments); 18 (450
msec.) is the factory setting.
3. Select another procedure, or exit programming mode.
4. If you are using Recall to access PBX or Centrex features, test the new Recall Timer setting:
■
If a call is disconnected, shorten the time.
■
If the Recall signal has no effect, lengthen the time.