Avaya programming and use, Installation And Use Manual, Page: 140 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Hold Reminder Tone (#127)
4-42
3. Press
D
until the appropriate value appears:
4. To program the next line, press
n
then repeat Step 3.
5. Repeat Step 4 for each line in the system.
6. Select another procedure, or exit programming mode.
Hold Reminder Tone (#127)
4
Use this feature to set the time interval at which the PARNTER system will provide a reminder tone
for a call on hold at a system telephone. When you place a call on hold, the PARTNER system will
provide the Hold Reminder Tone at your extension if the call remains on hold for the time interval
specified. You can disable the Hold Reminder Tone. (If you disable the Hold Reminder Tone, the
PARTNER system will not provide a reminder tone when a call is on hold.)
Considerations
4
■
This feature is available in PARTNER R6.0 and later systems.
■
When you program this feature via Set administration, the setting you specify will apply to all
analog lines. It will not apply to T1 lines. You must use the PARTNER ACS R6.0 PC
Administration software to program the Hold Reminder Tone for T1 lines.
Programming
4
To change the hold reminder tone time:
1. Press
f00ss#127
at extension 10 or 11. A display
similar to the following appears, showing the current Hold Reminder Tone setting:
Hold Timer
5 60 seconds
■
00 = No Detection
■
01 = 50 msec
■
02 = 100 msec
■
03 = 150 msec
■
04 = 200 msec
■
05 = 250 msec
■
06 = 300 msec
■
07 = 350 msec
■
08 = 400 msec
■
09 = 450 msec
(the factory setting)
■
10 = 500 msec
■
11 = 550 msec
■
12 = 600 msec