Avaya P333R, User Manual

Page: 95 / 270

Chapter 5 CLI – Layer 2
Avaya
P333T-PWR User’s Guide
75
The syntax for this command is:
show arp-aging-interval
Output Example:
P330-N> show arp-aging-interval
ARP table aging interval for gateways was set to 10 minutes.
show self-loop-discovery
Use the show self-loop-discovery command to display a switch’s IBM token ring
cable discovery status.
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a stack with P330-ML as the stack
master, a session should be opened to the relevant switch.
The syntax for this command is:
show self-loop-discovery [mod_num]
Output Example:
P330-N> show self-loop-discovery 1
Self-Loop-Discovery is disabled on module 1.
show allowed managers status
Use the
show allowed managers status
command to display the activation
status of the Allowed Managers feature. When this feature is enabled, only those
stations whose IP addresses are listed in the Allowed Managers table can access the
device over Telnet, SNMP, or HTTP.
The syntax for this command is:
show allowed managers status
Output Example:
P330-N> show allowed managers status
Managers are disabled.