Avaya P333R, User Manual

Page: 138 / 270

Chapter 5 CLI – Layer 2
118 Avaya
P333T-PWR User’s Guide
Output Example:
P330-N# set arp-tx-interval 15
ARP tx interval was set to 15 seconds.
set self-loop-discovery Admin_Status
Use the
set self-loop-discovery Admin_Status
command to enable or
disable IBM token ring discovery feature at the module level.
Note: You must disable Spanning Tree before you can enable self-loop-discovery.
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a stack with P330-ML as the stack
master, a session should be opened to the relevant switch.
The syntax for this command is:
set self-loop-discovery Admin_Status <enable|disable>
<modul num>
Example:
P330-N# set self-loop-discovery Admin_Status enable 1
Self-Loop-Discovery is disabled on module 1.
set welcome message
Use the
set welcome message
command to set a welcome message to appear
after a reboot or after opening a new session (see
session
command) in the stack.
The syntax for this command is:
set welcome message [string]
Output Example:
P330-N# set welcome message avaya
string string - The string to be used as the welcome message.
blank - Restores the default string.