Avaya P333R, User Manual

Page: 127 / 270

Chapter 5 CLI – Layer 2
Avaya
P333T-PWR User’s Guide
107
set port security
Use the
set port security
command to enable MAC security on a port or a
range of ports at the module level. The port security is activated only after you
enable the secutity mode at the stack level using the
set security mode
command.
Note: This command is not supported in P330-ML switches. This command is used
to set port security for ports in other P330 switches in the stack.
The syntax for this command is:
set port security { enable | disable } [<module>[/<port>]]
Output Example:
P330-N> set port security enable 1/2
Port 1/2 secured.
set cascading
Use the
set cascading
command to enable or disable fault-trap sending for
unconnected cascading links. The default setting is disable.
The syntax for this command is:
set cascading {up|down} fault-monitoring {enable|disable}
<mod-num>
Output Example:
P330-N# set cascading down fault-monitoring enable 1
Module 1 cascading-down fault monitoring enabled.
set inband vlan
Use the
set inband vlan
command to set a value for the management vlan
(from 1 to 3071).
enable | disable Set the port security enable or disable
module/port The switch number/the port number