Avaya P333R, User Manual

Page: 123 / 270

Chapter 5 CLI – Layer 2
Avaya
P333T-PWR User’s Guide
103
set internal buffering
The
set internal buffering
command allows you to set the size (either
Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the
specified switch. This command is meaningless when any port of the switch is
operating with flow control ON.
Note: This command is not supported by P330-ML switches. This command is used
to set the internal buffering for the other P330 switches in the stack.
The syntax for this command is:
set internal buffering <mod_num> {max|med|min}
Example:
P330-N> set internal buffering 1 max
Done.
set boot bank
Use the
set boot bank
command to configure the software bank from which a
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the
session
command.
Note: This command is not supported by the P333R and P333R-LB switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
set boot bank <value>
max Sets the internal receive buffer to its maximum size.
med Sets the internal receive buffer capacity dynamically
min Sets the internal receive buffer to its minimum size (this is the
Default).
value {bank-a | bank-b}