FIGURE 8
FIGURE 9
User’s Guide
Modular Amplifier
Depress “ON/OFF” button until the color indicator is visible.
Remove handset. If dial tone is not heard in the headset, move
slide switch to each position in turn. When a clear dial tone is heard,
go to the next step. If no dial tone is heard in any switch position,
move the switch to position 5 and install the AC/DC converter as
described above.
Adjusting the Transmit Level Dial
You may need to adjust the sound transmission level of your head-
set (what your caller hears). Before attempting this adjustment, com-
plete the installation of your headset. If needed, return to this section
to adjust the Transmit Level Dial.
Place a call to a friend and talk while rotating the dial with the screw-
driver. (FIGURE 5) Continue rotating until the optimum sound tone
and level are reached. The sound level should be the same as when
using the handset. You can check it by putting the handset to your
ear and then pushing the “ON/OFF” button so the indicator is black.
Once set, you do not have to readjust this dial unless you change
telephones.
Return the plastic mini-screwdriver to the bracket for future use.
USAGE
Quick Disconnect
™
Your headset model is equipped with a Quick Disconnect module.
This feature allows you to place a call on hold without removing
your headset, thus freeing you to perform a task away from the
phone. Your conversation is quickly resumed by reconnecting the
Quick Disconnect.
Before attempting to use your headset, be sure that the two Quick
Disconnect halves are connected.
To put your call on hold, grasp the Quick Disconnect as shown and
pull straight apart. (FIGURE 6)
To resume your conversation, reconnect the two halves of the Quick
Disconnect.
FIGURE 5
FIGURE 6
1
4
5
1
2
3
2
Placing and Receiving Calls with the Modular Amplifier
For headset use, depress the middle button labeled “ON/OFF” so
that the color indicator is visible. (FIGURE 7)
To place a call, remove the telephone handset from its cradle. You
should hear a dial tone. Dial normally. To end the call, hang up
the handset.
To receive a call, remove the handset from its cradle. You can now
hear and be heard by the calling party. To end the call, hang up
the handset.
For handset use, depress the “ON/OFF” (middle) button again so
that the color indicator does not appear. Pick up your handset as
you would normally.
Setting the Volume Control
To set the volume control to the hearing level most comfortable for
you, start with the wheel turned to number 1, the lowest level. To
increase the volume, rotate the wheel to a higher number.
Using the Mute Button on the Modular Amplifier
To mute your voice while still hearing the caller, depress the
MUTE (right) button so that the color indicator is visible. (FIGURE 9)
To resume speaking to your caller, depress the MUTE (right) button
again so that the color indicator does not appear.
IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT YOUR
AVAYA HELPLINE AT 1-800-628-2888.
49916-01 (12•00)
FIGURE 7
1
2
1
2
3
4
3
4
49916-01 AVAYA ModularAmplifier 11/29/00 18:49 Page 1
