Avaya Media Gateway G350, Maintenance Manual

Page: 88 / 332

Avaya Communication Manager controlled maintenance
CO-DS1 (DS1 CO Trunk)
88 Maintenance of the Avaya G350 Media Gateway
June 2004
Error Log Entries and Test to Clear Values
Notes:
•
(a) Error Type 1—Aux Data 57408
—
No tip ground is detected on an outgoing call. Aux Data
57487
—
PBX could not get “loop close” signal.
•
(b) Error Type 15—This is a software audit error that does not indicate any hardware malfunction.
Run Short Test Sequence and investigate associated errors (if any).
•
(c) Error Type 18—System Technician has busied out the trunk to the out-of-service state. No
calls can be made on this trunk except the Facility Access Test Call.
•
(d) Error Type 130—This error type indicates that the Media Module has been removed or has
been insane for more than 11-minutes. To clear the error, reinsert or replace the Media Module.
•
(g) Error Type 769—The DS1 Interface Media Module detects a hardware fault. The Aux Data
field contains the following error type:
—
57484, fault is detected on tip/ring.
•
(h) Error Type 1793—DS1 Interface Media Module is out-of-service. Look for MG-DS1 errors in
the Hardware Error Log. Refer to the DS1 Trunk Media Module or MG-DS1 Media Module
Maintenance documentation for details.
Table 42: CO-DS1 Trunk Error Log Entries
Error
Type Aux
Data
Associated Test
Alarm
Level On/Off
Board
Test to Clear Value
0* 0 Any Any Any test trunk <grp>/<mbr>
1(a) 57408
1(a) 57487
15(b) Any Port Audit and
Update Test (#36)
18(c) 0 busyout trunk
<grp>/<mbr> WARNING OFF release trunk
<grp>/<mbr>
130(d) None WARNING ON test trunk <grp>/<mbr>
769(g) 57484
1793(h) test board GGGVSpp l
2562(i)) 16665
2817(j) 52992
3840(k) Port Audit and
Update Test (#36)
*Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
**Major alarms MO may be downgraded to Warning alarms based on the value used in the set
options command.