Avaya G700, Installing And Upgrading, Page: 675 / 808

Upgrade the G700 Firmware
Issue 10.2 May 2007 675
Note:
Note:
Slot V1 can contain either a media module or the S8300, which will show as
TYPE ICC
.
7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the planning documentation.
8. Type
reset <module #>
where
<module #>
is the number of the G700 in the stack.
9. When the reset is finished, type
show mm
to verify the upgrade.
To release board (if media module was busied out)
1. When the upgrade procedure is complete, go to the SAT session and release the board
Type
release board v x
where
x
is the slot number of the upgraded media module.
2. Verify the response,
Command Successfully Completed
Note:
Note:
If you see the response,
Board Not Inserted
, this means that the media
module is still rebooting. Wait one minute and repeat the
release board
command.
3. Repeat the
release board
command for each media module that was busied out.
Ensuring the MGP default gateway IP address is set
Communication Manager release 4.0 requires that the built-in VoIP module of the G700 Media
Gateway has a default gateway IP address. To ensure that this IP address is set, perform the
following steps:
1. At the MG-???-1(configure)# prompt, type
show ip route mgp.
The list of mgp routes appears.
2. Check that a Gateway IP address exists for Destination
0.0.0.0
.
MG-001-1(super)# show ip route mgp
DESTINATION MASK GATEWAY INTERFACE (F/C/U)
--------------- --------------- --------------- ---------- -----------
0.0.0.0 0.0.0.0 135.9.80.254 motfec0 (3/0/165)
135.9.80.0 255.255.255.0 135.9.80.88 motfec0 (101/0/0)
MG-001-1(super)#