Avaya G700, Installing And Upgrading, Page: 514 / 808

Manual installation of a new G700 without an S8300
514 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Installing new firmware on the G700 Media Gateway Processor
To install MGP firmware
1. At the P330-1(configure)# prompt, type
session mgp
to reach the G700 media gateway
processor.
2. Type
configure
at the MG-???-1(super)# prompt to enter configuration mode, which will
change the prompt to MG-???-1(configure)# .
3. At the MG-???-1(configure)# prompt, type
show mgp bootimage
to determine which
disk partition (bank) is in the Active Now column.
You will update the bank that is not listed as Active Now. The system displays the following
screen:
Example: Show mgp bootimage
4. At the MG-???-1(configure)# prompt, type
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700,
where
<bank>
is the bank that is not Active Now (Bank A in the example).
<filename>
is the full path name of the mgp firmware image file, which begins with mgp
and will be similar to the name mgp_8_0.bin.
<tftp_server_ip_address>
is the IP address of the S8300.
For example:
copy tftp mgp-image a mgp_8_0.bin 195.123.49.54
The screen shows the progress.
5. Type
set mgp bootimage <bank>
where
<bank>
is the same letter you entered in the previous step.
6. At the MG-???-1(configure)# prompt, type
reset mgp
.
A system prompt asks you to confirm the reset.
FLASH MEMORY IMAGE VERSION
Bank A 109
Bank B 210
ACTIVE NOW ACTIVE AFTER REBOOT
Bank B Bank B