
Manual installation of a new G700 with an S8300
450 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
10. At the
MG-???-1(super)#
prompt, type
configure
to reach the configuration level of the
command line interface.
11. Type
show interface mgp
to verify that the G700 media gateway has the correct IP
address.
To assign the default IP route to the G700 media gateway
!
CAUTION:
CAUTION:
The default gateway IP routing address is
required
for Communication Manager
4.0.
1. At the
MG-???-n(configure)#
prompt, type
set ip route
0.0.0.0 0.0.0.0
<default_gateway>
to specify the gateway to handle addresses outside of the local subnet.
<default_gateway>
is the IP address of the default network gateway. This address
should be available in the planning documentation.
2. Type
show ip route mgp
to view the results.
3. Repeat Step 1 for additional ip routes, if needed.
Usually, only a default route is needed. Refer to your planning document.
From the G700 media gateway processor command line interface, you assign IP addresses to
the VoIP resource resident on the G700 media gateway and to any installed MM760 VoIP media
modules.
To assign IP addresses to the VoIP resources
1. At the
MG-???-n(configure)#
prompt, type
set interface voip
<number> <ip
address>
<number>
is the slot number of the VoIP media module.
v0
designates the VoIP resource
resident on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are
designated according the slot (for example,
v1
,
v2
,
v3
,
v4
) in which the media module has
been installed.
<ip address>
is the IP address of the VoIP resource.
For example:
set interface voip v0 132.236.73.3
2. Type
show interface
to display a table of all configured interfaces, including all VoIP
Media Modules.
3. Type
show voip v0
to display the VoIP resource on the motherboard.
Note:
Note:
It is not necessary to configure the VLAN, netmask, or IP routes for VoIP engines.
The media gateway parameters are applied automatically.
Summary of Contents for G700
Page 38: ...38 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server ...
Page 404: ...404 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server ...
Page 808: ...808 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server Index ...