Avaya G700, Installing And Upgrading, Page: 424 / 808

Manual installation of a new G700 with an S8300
424 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Server Date/Time Window
2. Verify or set the media server's time close enough to the NTS's time, date, and time zone
that synchronization can occur (within about 5 minutes).
!
CAUTION:
CAUTION:
If you are installing an LSP, you must set the time of the LSP to the same time
zone as the primary controller even if the LSP is physically located in a different
time zone.
Creating a super-user login, if necessary, for R4.0 or higher
If a super-user login does not exist, you must add at least one before you complete the upgrade.
The easiest way to add a login is with the Maintenance Web pages. Use the following steps only
if you are starting from Release 4.0 software or later:
Note:
Note:
A craft level login can create a super-user login in Release 4.0 or later.
Note:
Note:
If you are installing software for an S8300 LSP, create the super-user login on the
primary controller. Then, at the LInux command line on the primary controller, run
the
filesync -a <IP_address_of_LSP>
command.