228
Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Completing the Installation Administration
May 2003
You must assign a product ID number to the configuration. You can obtain this product ID
number from the Automatic Registration Tool (ART) script or your Avaya Business Partner
representative.
1
Click Start > Run to open the Run dialog box
2
Type telnet 192.11.13.6 and press
Enter
.
3
Log in as craft or dadmin (if business partner).
4
At the prompt type
productid -p
number
and press
Enter
.
Add INADS phone numbers
NOTE:
Do these steps only if the customer has a maintenance contract with Avaya.
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1
Click Start > Run to open the Run dialog box
2
Type telnet 192.11.13.6 and press
Enter
.
3
Log in as craft or dadmin (if business partner).
4
At the prompt type almcall -f 9,18005353573 (if a direct line, you do not need the 9,)
5
If alarms will be reported to a second number type almcall -s second-number and press
Enter
.
6
At the prompt type almcall and press
Enter
. Verify that the proper information has been
entered.
Enable alarms to INADS via modem
NOTE:
Do these steps only if the customer has a maintenance contract with Avaya.
The following administration is done on a computer used to access the active Avaya S8700
Media Server using an MS-DOS command line interface.
1
Click Start > Run to open the Run dialog box
2
Type telnet 192.11.13.6 and press
Enter
.
3
Log in as craft or dadmin (if business partner).
4
At the prompt type
almenable -d b and press
Enter
.
5
Type
almenable and press
Enter
to verify that the alarms are enabled.
6
Log off.
