Avaya ERS 8600 series, Configuration Manual

Page: 382 / 420

Table 34: Command parameters
Parameter Description
act-id Specifies a unique identifier (in the range 1–
4096) for this ACT entry.
If you provide no <act-id> , the command shows switch-wide ACT configuration data.
Important:
Any show command that displays information that cannot fit on oe screen appears as two
tables: Part 1 and Part 2.
ACT pattern data
Use the
show filter act-pattern
command to display ACT pattern data. The syntax for
this command is as follows.
show filter act-pattern [
<act-id>
]
The following table explains parameters for this command.
Table 35: Command parameters
Parameter Description
act-id Specifies a unique identifier (in the range 1–
4096) for this ACT entry.
The following figure shows sample output for this command.
Figure 27: show filter act-pattern command output
Basic OSPF information about a port
Use the
show ports stats ospf main port
command to display basic OSPF
information about the specified port or for all ports. The syntax for this command is as follows.
CLI show commands
382 Configuration — IPv6 Routing November 2010