Avaya ERS 8600 series, Configuration Manual, Page: 361 / 420

Variable Value
Dest Displays the IPv6 destination network address. The prefix value
must match the PrefixLength.
PfxLength Displays the number bits you want to advertise from the prefix.
The prefix value must match the value in the Dest field. The
range is 0 to 128.
IfIndex Displays the ID for the VLAN or port.
NextHop Displays the IPv6 address of the next hop of this route.
Protocol Displays the routing protocol (OSPF).
Metric Displays the metric assigned to this interface. The default value
of the metric is the reference bandwidth or ifSpeed. The value
of the reference bandwidth is configured by the
rcOspfv3ReferenceBandwidth object.
Viewing IPv6 attributes for an ACL
View IPv6 attributes for an ACL to view ACE Advanced entries associated with an ACL.
Procedure steps
1. In the navigation tree, open the following folders: Configuration, Security, Data
Path .
2. Double-click Advanced Filters (ACE/ACLs) .
3. Click the ACL tab.
4. Select any of the parameters of an IPv6 ACL.
5. Click
IPv6 .
Variable definitions
Use the data in the following table to use the ACE IPv6, ACL (x) dialog box.
Variable Value
ACL ID Specifies the unique identifier for the ACL.
ACEID Specifies the unique identifier for the ACE.
SrcAddrList Lists the source IPv6 addresses.
SrcAddrOper Specifies equal (eq) or not equal (ne) or any in relation to the
listed source addresses.
Viewing IPv6 attributes for an ACL
Configuration — IPv6 Routing November 2010 361