Avaya ERS 8600 series, Configuration Manual

Page: 352 / 420

Variable Value
LocalIfIndex A read-only field indicating the identifier of the link from which the LSA
was received.
Type A read-only field indicating the OSPF interface type. By default,
switches can determine this value from the corresponding value of
ifType. Broadcast LANs, such as Ethernet and IEEE 802.5, use the
value broadcast; X.25 and similar technologies use the value nbma;
and point-to-point links use the value pointToPoint.
RouterId A read-only field indicating the 32-bit integer that uniquely identifies the
router in the autonomous system.
Lsid A read-only field indicating that the link-state ID is an LS type-specific
field containing either a router ID or an IPv6 address. It identifies the
piece of the routing domain described by the advertisement.
Sequence A read-only field indicating that the sequence number is a signed 32-
bit integer that identifies old and duplicate link-state advertisements.
Age A read-only field indicating the age in seconds of the link-state
advertisement.
Checksum A read-only field indicating the checksum of the complete contents of
the advertisement, except the age field. The age field is not affected so
that the advertisement age value increments without updating the
checksum. The checksum used is the same for ISO connectionless
datagrams, the Fletcher checksum.
TypeKnown A read-only field indicating the LSA type recognized by this router.
Viewing virtual links on neighboring devices
You can view area and virtual link configuration for the neighboring device on the Virtual
Neighbor tab.
Procedure steps
1. In the navigation tree, open the following folders: Configuration, IPv6 .
2. Double-click OSPF .
3. Click the Virtual Neighbors tab.
Variable definitions
Use the data in the following table to use the Virtual Neighbors tab.
Common procedures using Enterprise Device Manager
352 Configuration — IPv6 Routing November 2010