Avaya ERS 8600 series, Configuration Manual

Page: 331 / 420

Adding an ACE with IPv6 header attributes
Add an ACE with IP header attributes as match criteria.
Important:
Be aware of the following:
• You cannot select (*) after <ace-op>.
• If you select no entry, You delete the Ethernet, ARP, or IPv6 protocol node.
Procedure steps
Add an ACE with IPv6 header attributes by using the following command:
config filter acl
<acl-id>
ace
<ace-id>
ipv6
Variable definitions
Use the data in the following table to use the
config filter acl ace ipv6
command.
Variable Value
ace-id Specifies an ACE ID in the range 1–1000.
acl-id Specifies an ACL ID in the range 1–4096.
delete <ipv6-attributes> Deletes the specified IPv6 ACE attributes.
dst-ipv6 <ace-op> <dst-ipv6-list> Specifies the following:
• an operator for a field match condition (eq)
• the list of destination IPv6 addresses separated by
commas
info Displays the current level parameter setting and the
next level directories.
nxt-hdr <ace-op> <nxt-hdr> Specifies the following:
• an operator for a field match condition (eq | ne)
• the next header value
src-ipv6 <ace-op> <src-ipv6-list> Specifies the following:
Adding an ACE with IPv6 header attributes
Configuration — IPv6 Routing November 2010 331