Avaya ERS 8600 series, Configuration Manual

Page: 284 / 420

Configuring OSPF on a tunnel
Configure OSPF on a VLAN or brouter tunnel to create a dynamic IPv6 tunnel on the OSPF
interface.
Prerequisites
You must log on to the Global Configuration mode in the ACLI.
Procedure steps
1. Configure OSPF on a tunnel by using the following command:
ipv6 tunnel <tunnel id> [dead-interval <seconds>] enable
[hello-interval <seconds>] [metric <value>] [poll-interval
<seconds>] [priority <value>] [retransmit-interval
<seconds>] [transmit-delay <seconds>]
2. Configure the OSPF area for the tunnel by using the following command:
ipv6 tunnel <tunnel id> area <A.B.C.D> [dead-interval
<seconds>] [hello-interval <seconds>] [metric <value>]
[priority <value>] [retransmit-interval <seconds>]
[transmit-delay <seconds>]
Variable definitions
Use the data in the following table to use the
ipv6 tunnel
command.
Variable Value
area <A.B.C.D> Configures the area IP address (0.0.0.0 to
255.255.255.255) {a.b.c.d}.
dead-interval <seconds> Configures the OSPF dead interval for the interface.
seconds is the number of seconds the switch OSPF
neighbors wait before determining that this OSPF
router is down. The range is from 1-4095. This value
IPv4-to-IPv6 transition mechanism configuration using the ACLI
284 Configuration — IPv6 Routing November 2010