Avaya ERS 8600 series, Configuration Manual

Page: 241 / 420

Command Parameter
clear ipv6 vrrp {fastethernet <slot|port>|
gigabitethernet <slot|port>| vlan <vid>} vrid
<value>
Configuring VRRP on a port or a VLAN
Use the following procedure to configure VRRP on a port or a VLAN.
Prerequisites
• Access Interface configuration mode.
• Enable IPv6 forwarding globally.
• Configure IPv6 on the interface.
Procedure steps
1. Configure the VRRP address on a port by using the following command:
ipv6
vrrp address <1-255> {[global <X:X:X:X:X:X:X:X>/len] [link-
local <fe80::X:X:X:X>}
2. Configure VRRP properties on a port by using the following command:
ipv6 vrrp
<1-255>
3. Enable the VRRP instance by using the following command:
ipv6 vrrp <1-255>
enable
4. Delete VRRP from the port by using the following command:
no ipv6 vrrp
<1-255>
5. Show the global VRRP settings by using the following command:
show ipv6
vrrp
Variable definitions
Use the data in the following table to configure VRRP.
Configuring VRRP on a port or a VLAN
Configuration — IPv6 Routing November 2010 241