Avaya CallPilot 703t, Hardware Installation, Page: 42 / 52

Connecting the server to the ELAN subnet
Connect the CallPilot server to the Meridian 1 switch or CS 1000 system using the Embedded
LAN (ELAN).
Important:
For important considerations about using the ELAN subnet in your network, see the Planning
and Engineering Guide (NN44200-200).
Important:
To comply with EMC requirements, a Class A hub must be located 10 m (33 feet) away from
the 703t server.
To connect the server to the ELAN subnet (Meridian 1 or CS
1000 only)
1. Locate the ELAN Ethernet connector on the back of the server.
Note:
The ELAN connector is labeled as NIC1 10/100 MB. For the connector location,
see the diagram on Rear panel on page 39.
2. Connect an RJ-45 network cable from the ELAN hub to the server's ELAN
connector.
Note:
The ELAN hub is optional if you use a cross-over network cable to make a direct
point-to-point connection from the server to the switch. However, if you choose
to establish a direct point-to-point ELAN subnet connection, no other device can
connect to the ELAN subnet.
3. At the switch, connect the ELAN network cable to an MAU (Ethernet) transceiver.
Then complete the connection from the transceiver to the switch.
Danger:
Risk of fire hazard
The NTRH9069 MAU is not suitable for installation in ducts, plenums, or other
spaces used for environmental air. Do not install it above a false ceiling or below a
Installing the server and connecting the peripheral devices
42 Avaya CallPilot® 703t Server Hardware Installation December 2010