Installing the monitor, keyboard, and mouse
Introduction
You must connect the monitor, keyboard, and mouse to the 201i server so that you can:
• observe the 201i server startup process.
• run the Configuration Wizard.
• perform initial administration after installation.
Note:
The 201i server is not intended to operate with permanent monitor, keyboard, and mouse
connections. Once you have successfully started and configured the 201i server, remove
the monitor, keyboard, and mouse. For day-to-day administration, use a web browser on a
PC that is connected to the ELAN subnet or Avaya server subnet.
Hardware requirement
Caution:
Risk of equipment damage
The mouse connector on the 201i faceplate is a PS/2 connector. If you plan to use a USB
mouse with USB-to-PS/2 converter, you must also use the Avaya-supplied 4-inch PS/2
extension cable (A0855616).
Without the extension cable, the USB-to-PS/2 mouse connector is partially blocked by the
monitor connector.
PS/2 extension cable
The following diagram shows the PS/2 extension cable connected between the 201i server
and the USB mouse with USB-to-PS/2 converter.
Installing the monitor, keyboard, and mouse
Avaya CallPilot
®
201i Server Hardware Installation
December 2010 113