Avaya Cajun P580, User Manual, Page: 300 / 770

10-10 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.0
Chapter 10
3. Click APPLY to enable the redundant element.
The Switch Elements field displays:
Normal # 0
This indicates that the redundant element is now enabled.
4. Save the configuration changes
CLI Command
To enable an element using the CLI, enter the following command from
Configure mode:
> set fabric configure-redundant-hardware enable
Configuring Supervisor Module Redundant
Ethernet Console IP Addresses
Web Agent
Procedure
If you need to communicate with both the Active and Standby Supervisors,
configure an alternate Ethernet Console IP address for both. Configure an
alternate IP address for both slot 1 and 2 CPU’s, by using the Web Agent or
the CLI.
* Note: Do not Login to a Standby Supervisor module to manage the
switch. The Standby Supervisor does not have accurate switch
status information until it becomes the Active Supervisor.
To identify the Active or Standby supervisor, look at the LED
display (marquee), or open the System > Configuration >
CPU Redundancy > Status/Statistics folders from the web
agent, or use the
show CPU status
CLI command.
To configure a redundant console IP address by using the Web Agent:
1. Select Configuration from the System > Configuration > CPU
Redundancy group on the Web Agent window. The CPU Redundancy
Configuration dialog box opens (
Figure 10-6 )