Avaya C360 Manager, Installation And Configuration Manual

Page: 67 / 248

Establishing a Telnet Connection
Issue 2 July 2005 67
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the C360 for configuration of
Stack or Router parameters. You can Telnet the Stack Master IP address:
1. Connect your station to the network.
2. Verify that you can communicate with the C360 by pinging the IP of the C360. If there is no
response using ping, check the IP address and default gateway of both the C360 and the
station.
Tip:
Tip:
The C360 default IP address is 149.49.32.134 and the default subnet mask is
255.255.255.0.
3. From the Microsoft Windows taskbar of your PC click Start and then Run (or from the DOS
prompt of your PC), then start the Telnet session by typing:
telnet <C360_IP_address>
For example:
telnet 149.49.32.134
4. If the IP Address in the Telnet command is the IP address of the stack, then connection is
established with the Switch CLI entity of the Master module.
●
The "Welcome to C360" screen appears
5. Enter the default name
root
at the Login name prompt.
6. Enter the User Level password
root
in lower case letters (do not use uppercase letters) at
the Password prompt.
●
The User level prompt will appear when you have established communications with the
C360.
You can now configure the C360 stack and change its IP address.