Avaya 4524GT, Configuration Manual

Page: 85 / 362

Variable Value
verbose Copies the entire configuration, including defaults and non-
defaults.
Important:
Use the
copy running-config tftp
command only from the base unit in a stack.
copy running-config usb command
To copy the contents of the current configuration file to a USB storage device, use the following
command in Privileged EXEC command mode.
copy running-config usb [filename <WORD>] [module <value>] [verbose]
You can enter
[module <value>]
parameters individually or in combinations.
You can also execute this command in the Global Configuration command mode.
Variable definitions
The following table defines the parameters that you enter with the
copy running-config
usb [filename <WORD>] [module <value>] [verbose]
command.
Variable Value
filename <WORD> Specifies the filename to store configuration commands on the
TFTP server.
module <value> Display configuration of an application for any of the following
parameter values: [802.1ab] [aaur] [adac] [arp-inspection]
[asset-id] [aur] [banner] [core] [dhcp-relay] [dhcp-snooping]
[eap] [energy-saver] [interface] [ip] [ip-source-guard] [ipfix]
[ipmgr] [ipv6] [l3] [l3-protocols] [lacp] [logging] [mac-security]
[mlt] [nsna] [port-mirroring] [qos] [rate-limit] [rmon] [rtc] [snmp]
[ssh] [ssl] [stack] [stkmon] [stp] [vlacp] [vlan]
verbose Copies the entire configuration, including defaults and non-
defaults.
script command
Use the
script
command to create an entry (either a TFTP or an USB entry) in the ASCII
configuration script table.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
Configuration files in ACLI
Configuration — System April 2011 85