Avaya 4524GT, Configuration Manual

Page: 74 / 362

This command has no parameters and clears any previously configured RADIUS
server settings.
3. radius-server password fallback
This command has no parameters and enables the password fallback RADIUS
option if it you did not set the option when you initially configured the RADIUS
server.
Changing switch software in ACLI
Perform the following procedure to change the software version that runs on the switch with
ACLI:
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
1. Access ACLI through the Telnet protocol or through a Console connection.
2. From the command prompt, use the download command with the following
parameters to change the software version:
download [address <ipv6_address> | <a.b.c.d>] {image <image
name> | image-if-newer <image name> | diag <image name> |
poe_module_image <image name>} [no-reset] [usb]
The following table describes the parameters for the
download
command.
Table 13: download parameters
Parameter Description
address <ipv6_address> |
<a.b.c.d> The IPv6 or IP address of the TFTP server you use.
The address <ipv6_address> | <a.b.c.d> parameter
is optional and if you omit it, the switch defaults to
the TFTP server specified by the
tftp-server
command unless software download is to occur
using a USB Mass Storage Device.
image <image name> The name of the software image to be downloaded
from the TFTP server.
image-if-newer <image
name> This parameter is the name of the software image
to be downloaded from the TFTP server if it is newer
than the currently running image.
diag <image name> The name of the diagnostic image to be downloaded
from the TFTP server.
System configuration using ACLI
74 Configuration — System April 2011