Avaya 4524GT, Configuration Manual

Page: 167 / 362

Variable Value
• tagged—uses a tagged VLAN
• untagged—uses an untagged VLAN or does not
support port-based VLANs.
If you select untagged, the system ignores the VLAN
ID and priority values, and recognizes only the DSCP
value.
vlan-id <0-4094>
Specifies the VLAN identifier for the selected port or
ports. Values range from 0–4094 (0 is for priority
tagged frames). If you select priority tagged frames,
the system recognizes only the 802.1p priority level
and uses a value of 0 for the VLAN ID of the ingress
port.
lldp tx-tlv command
The
lldp tx-tlv
command sets the optional Management TLVs to be included in the
transmitted LLDPDUs.
The syntax for the
lldp tx-tlv
command is:
lldp tx-tlv [port <portlist>] [local-mgmt-addr] [port-desc] [sys-cap]
[sys-desc][sys-name]
Run the
lldp tx-tlv
command in Interface Configuration command mode.
The following table describes the variables for the
lldp tx-tlv
command.
Table 77: lldp tx-tlv command variables
Variables Description
local-mgmt-addr
The local management address TLV. This TLV is
enabled by default.
port-desc
The port description TLV This TLV is enabled by
default. This TLV is enabled by default.
port <portlist> Specifies a port or list of ports.
sys-cap The system capabilities TLV.
sys-desc
The system description TLV. This TLV is enabled by
default.
sys-name
The system name TLV. This TLV is enabled by
default.
Configuring LLDP using ACLI
Configuration — System April 2011 167