Avaya 4524GT, Configuration Manual

Page: 149 / 362

no rate-limit command
The
no rate-limit
command disables rate-limiting on the port.
The syntax for the
no rate-limit
command is:
no rate-limit [port <portlist>]
Run the
no rate-limit
command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 65: No rate-limit parameters
Parameters Description
port <portlist> Specify the port numbers to disable for rate-limiting. Enter the
port numbers to disable.
Important:
If you omit this parameter, the system uses the port number
you specified in the
interface
command.
default rate-limit command
The
default rate-limit
command restores the rate-limiting value for the specified port
to the default setting.
The syntax for the
default rate-limit
command is
default rate-limit [port <portlist>]
Run the
default rate-limit
command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 66: Default rate-limit parameters
Parameters Description
port <portlist> Specify the port numbers to reset rate-limiting to factory default.
Enter the port numbers to set rate-limiting to default.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface command.
General switch administration using ACLI
Configuration — System April 2011 149