CHAPTER 7
Instructions, use and maintenance manual
Page 56
D r a g o P Z e r o
7.2. SAFETY WARNINGS
CAUTION!
For the maintenance activities, close the gas supply system.
•
Maintenance operators are required to wear all of the personal protective equipment (gloves, goggles)
necessary to perform the operation.
•
During maintenance operations, unauthorised staff must stay out of the relative operating area.
• If the operation entails removing protections, set barriers up around the area and display signs forbidding
access to anyone who is not directly involved in the maintenance work.
The need to place the burner under operating conditions and/or with the protections disabled, requires an adequate
competence and knowledge and extreme caution by the maintenance engineer that must be adequately trained
on possible and existing risks.
The safety precautions in this paragraph must always be strictly observed, during maintenance of the machine to
avoid injuries to personnel and damage to the equipment:
•
Before proceeding with any maintenance activities, check that the energy sources are disconnected.
•
Only perform the interventions with the machine stopped and de-energised.
•
Padlock the gas supply tap.
•
He must be able to use the most suitable and adequate instruments to find the fault and know the most
suitable equipment for the maintenance interventions.
To perform certain maintenance operations, it could be necessary that the protections and safety devices be
deactivated and the guards open. In that case, operators are in hazardous conditions and the following rules
must be strictly respected:
CAUTION!
Maintenance personnel must be authorised and specifically instructed regarding the safety and
operating procedures to be followed, the danger situations which could arise and the correct
methods to avoid them.
IMPORTANT!
During these operations, personnel must pay the utmost attention and operate with extreme
caution.
