Avanti MBD5L, Instruction Manual

Page: 11 / 38

11
For the last two types of kegs, fit the orange all-purpose plug delivered with your appliance in the
existing keg hole further to cutting the plug.
CAUTION: allow the beer to rest before piercing the plug so as to avoid projections.
When the keg is empty, remove the orange all-purpose plug and clean it with dishwashing liquid.
Carefully rinse the plug. It is then ready for use with another keg.
f) Piercing pin:
For easier installation of the dispensing unit and the piercing pin, place it under running water
so that it is wet at the time of insertion.
Fit the bit vertically and drive it vigorously into the keg.
Then, secure the dispensing head on the keg, pull the locking latch outwards then release it. A
click should be heard, indicating that the dispensing head is correctly secured on the keg.
IMPORTANT:
Once the keg is pierced, the beer contained must be consumed within 28 days, provided that it
remains refrigerated.
Setting up the keg
•
Open the door by depressing the push button located over the door on the right.
•
Place the keg on the refrigerating stand, making sure that the female plug of the dispensing head
is on the right.
•
Connecting the hoses: the female plug of the dispensing head corresponds to the gas inlet. The
male plug corresponds to the beer outlet.
•
Close the door.
Setting up the gas cartridge
a) 16 gram cartridge (Three (3) cartridges are provided with your appliance).
•
A 16 gram cartridge can dispense at least one 5L keg.
•
Open the side panel compartment located on the right-hand side of your Mini Pub so as to
reveal the gas cartridge housing.
•
Make sure that the pressure gauge valve is shut (to shut the valve, turn it
counterclockwise).
•
Attach the pressure gauge on the end piece of the adapter, all the way unit it is completely
tight.
•
Insert the 16 gram CO
2
cartridge in the long part of the adapter.
•
Screw the two parts of the adapter together until you hear a “CLICK”, this will indicate that the
cartridge seal has been pierced and the CO
2
gas will flow freely. Proceed to secure the two
parts together until they make a tight fit to avoid a CO
2
leakage.