avantec DT910, User Manual, Page: 17 / 24

17
8.3 Select a Base (Multiple Base Scenario)
In case a handset is registered to more than one base station, you may
use this option to select between multiple base stations. (A handset
can register to a maximum of 4 base stations)
1.
In standby mode, press key to enter the handset menu.
2. Press key until “ BS SETUP ” is displayed.
3. Press key, then press key until
“ SEL BASE ” is displayed.
4. Press key, then use key to select
the desired base unit.
5. Press key to validate and start
registration, “ SEARCHING ” is displayed.
6. Upon successful completion, the handset
will return to standby screen and the
assigned handset number will be shown
“
HANDSET 1 ”.
In most cases, you may simply leave this setting
“
AUTO ” (Automatic), the handset will
automatically choose its registered base unit.
8.4 Advance Setup
8.4.1 Dial mode
Use this option to select Tone/Pulse dial mode.
1.
In standby mode, press key to enter the handset menu.
2. Press key until “ BS SETUP ” is displayed.
3. Press key, then press key until “ ADVANCE SET ” is
displayed.
4. Press key, and enter PIN code
(default as “0000”), “ DIAL MODE ” is
displayed.
5. Press key, then use / key to
switch between “Tone” or “Pulse”.
6. Press key to save the change.
7. Press key to go back to standby screen.