AVANT e5 2018, Operator'S Manual

Page: 52 / 108

Avant e5
52
.
Stopping the loader (Safe stopping
procedure)
WARNING
Safe stopping procedure
Stopping the loader and its
attachment to a safe state
1.
Lower the boom completely
down.
2.
Stop any attachment (move
auxiliary hydraulics control
lever to neutral position, see
page 38), set hand throttle to
rear position. Place the
attachment firmly on the
ground.
3.
Engage the parking brake.
4.
Stop the motors by turning
the ignition key to the OFF
position (turn to the left).
5.
Release auxiliary hydraulics
pressure (see page 66).
Move the boom control lever
and the control lever of the
telescopic boom towards all
of their extreme positions to
release residual pressure
from the hydraulic circuits of
the boom.
6.
Prevent unauthorised use of
the loader. Take the ignition
key with you. If parking on a
slope is necessary, use
additional wheel chocks to
prevent the loader from
moving.
.
.
Stop if you notice any of the following:
Stop the loader to a safe state as
soon as possible if you observe
any of the following symptoms.
Find out the cause before
restarting.

Battery charge level is below 10 %. Drive to
a charging location and avoid heavy load

Electric motor rpm increases and/or
decreases suddenly by itself, even if you
don't move the throttle lever, or press the
pedals

You notice sudden increase in vibration or
noise levels

You notice a leak
.
.
Battery disconnect switch
The loader is equipped with an electrically controlled
battery disconnect switch (main switch) - There is no
separate, manually usable main switch. Whenever
ignition key is switched to position
OFF the 12 V DC
system is switched off, and the contactor for the
inverters of the electric motors is also off.
To switch on the 12 V electric systems of the loader,
turn the ignition key to position
P . In position ON also
the main contactor for the electric motors is switched
on.