AVANT e5 2018, Operator'S Manual

Page: 31 / 108

Avant e5
31
Lift capacity
Lift capacity and Tipping load
The lifting capacity of the loader is limited either by the maximum available lift force of the loader boom, or by the
tipping load of the loader. The lifting capacity will depend on the position of the loader boom (the horizontal
distance of the weight in the forward direction), as is illustrated in different charts in this chapter. In most cases the
tipping of the loader is the limiting factor for lift capacity.
Unless specifically noted, all shown values refer only to the tipping load of the loader, and do not represent the lift
capacity of the loader.
Tipping load
Tipping load is the load at which the rear tyres lose
contact with the ground and the loader begins to tip
forward. Tipping over can happen also on even
ground. If the movement that causes the loss of
stability is not prevented or corrected in time, the
loader can tip over causing potentially serious
personal injuries or even death. Read the
instructions in this manual regarding safe handling of
loads to avoid the situation where the loader will tip
over.
Tipping over can be caused by a single reason, or as
the combined effect of the operating conditions,
movements of the loader, and the work situation.
Avoid the following basic situations to prevent the
loader from tipping over:

too heavy load is being lifted

when the loader boom is moved to another
position, the load moves away from the loader,
reducing the stability of the loader

driving or other movements of the loader affect
the balance of the loader
More information about how to take these factors
influencing the tipping load into account are shown
on page 59.
There are many influencing factors that affect the
stability of the loader. Use the load chart and ROC
table to estimate the load handling capacity of the
loader. Observe the instructions and information
given in this manual.
.
WARNING
Risk of tipping over - Follow
safety instructions. The lifting
capacity of the loader is limited by
the possibility of tipping around the
front axle.
Pay attention to safe operating
conditions whenever handling
loads or heavy attachments. The
indicated values apply only in
favorable conditions. Read the
instructions in this manual.
The lifting capacity and the stability of the loader
are at the best, when:

the ground is level

the loader frame is kept in straight position

the centre of gravity of the load is as close to the
loader as possible

counterweights are fitted to the loader

swinging of the load is prevented and all controls
are used in a calm and careful manner - sudden
movements of the loader or the load can cause
the loader to tip over
See also page 58 for more information about safe
handling of heavy loads and for a list of typical
factors that influence the stability of the loader.