AVANT A440199, Operator'S Manual For Attachment

Page: 27 / 34

27 (34)
7.5 Lubrication
There are a total of 4 lubricating points
at the joints of the attachment.
Appropriate lubrication interval
depends heavily on use and operating
conditions. Lubricant must be added at
least after every 10 hours of use.
Adequate lubrication must be ensured,
and if the bearings are dirty, lubricant
must be added; added lubricant will
push out dirt.
Clean the end of the nipple before
greasing and add only a small amount
of grease at a time. All lubrication
nipples are standard R1/8" nipples.
Replace any damaged nipples.
7.6 Assembling the cutting head on the left
7.6.1 Safety instructions for hydraulic assemblies
High-pressure ejection of fluid may penetrate skin and cause serious injuries:
DANGER
Risk of high pressure fluid injection
through skin - High-pressure ejection of
fluid may penetrate skin and cause serious
injuries.
Before handling hydraulic components, make
sure that the hydraulic system of the
attachment and the loader are completely
depressurized. Never handle pressurized
fittings.
Never hold your hand tightly around or near a
fitting when tightening or opening it, or when
searching for leaks. Use a piece of cardboard
to find leaks.
Seek medical attention immediately in case
hydraulic fluid is injected through the skin. Also
general skin contact with the oil can be
harmful. Always wear protective gloves, safety
goggles and protective clothing.