AVANT 735 2020, Operator'S Manual

Page: 45 / 140

Avant 735 Lift capacity
45
.
How to estimate actual lifting capacity
The actual tipping load and stability of the loader depends on many factors that you must consider when you
handle heavy loads or attachments. Listed in the table below are many factors that influence the stability of the
loader.
Always keep in mind the conditions listed in the following table.
Influencing factor How you should take it into account
Position of the loader boom
and telescope Keep load as close to the ground as possible while you drive. Lift only when
ready to unload the bucket or attachment

See load chart and ROC table to estimate the lift capacity of the loader on
level ground. Reduce the indicated maximum load by always taking the
local operating conditions into account
The total load on the loader
boom Estimate the combined weight of an empty attachment and load

Load chart is based on weight of pallet forks (90 kg)

If the attachment you use is heavier, subtract its weight from the listed
tipping load accordingly

See the operator's manual of each attachment for attachment weight and
possible information about permitted loads.
The distance of the load
from the front tyres The further away the load is from the loader, the less stable the loader is

Keep the load as close to the ground and the loader as possible

Never drive while load is lifted more than just off the ground
Straight or articulated
position of the loader frame If you turn the articulated frame, the loader will tip over more easily

Keep the loader in straight position when lifting heavy loads
Levelness of the ground All listed values are applicable only on level, even ground

Drive slowly on uneven ground

Keep load close to ground and as close to the loader as possible
Installed counterweights If counterweights are installed, the loader stability is better

Keep standard counterweights fitted

Consider the use of additional counterweights or ballasted tyres for
additional stability
Driver presence Driver acts as additional counterweight

Load chart is calculated with a 75 kg driver present on driver's seat

If you leave the driver's seat, loader can tip forward.
Movements of the loader
and the load Lifting of the maximum load is possible only when loader is not moving

Operate the controls of the loader slowly and in a smooth manner.
Dynamic loads can cause loader to tip over

Secure load on the attachment. If load moves or swings, the loader can tip
over

Use correct type of attachment for each type of load

Never lift swinging loads