BFC-07R1
14 BFC-07R1 Quick Reference Guide
2.3 RSC-IMX61 Jumper and Connector List
You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the board’s jumpers and connectors.
Jumpers
Label
Function
Note
SW1
Boot set selector
DIP switch 6pin
Connectors
Label
Function
Note
JBAT1
Battery connector
2 x 1 wafer, pitch 1.25mm
JMPCIE1
Mini-PCI connector
Mini card
JPWR1
DC Power-in connector
JMSD1
SD Memory Card Socket
SDCARD_9H, Push/Push Type
JCAN1
Can Bus connector
4 x 1 wafer, pitch 2.00mm
JTOUCH1
Touch Panel connector
4 x 1 wafer, pitch 2.00mm
JSPL1
Speaker L connector
2 x 1 wafer, pitch 2.00mm
JSPR1
Speaker R connector
2 x 1 wafer, pitch 2.00mm
