6
4.1 Connecting the Monitor to the AVT-3350
To make certain your PC monitor or HD component TV is working properly,
check that a PC or HD component source device can produce a picture on it
before attempting to use it with the AVT-3350. If all is well, connect the monitor or
HD component TV to the output of the AVT-3350 using a high quality cable.
Note: If you do not know the maximum resolution that your monitor is capable of
accepting, set the AVT-3350 to XGA resolution using the three position switch
located on the output side of the unit initially. By the same token, if you are
unsure how high of a HD resolution your component HD TV can reproduce, set
the three position switch to 480p.
4.2 Connecting the Input to the AVT-3350
You can connect either a NTSC or a PAL input signal to the AVT-3350. The unit
will automatically determine which type signal it is receiving. For the signal cable
type, you’ll want to use S-Video if possible because it will produce the best
picture in most cases. With either input always use a high quality cable, as short
a length as possible, for best results.
4.3 Connecting Power to the AVT-3350
The AVT-3350 is shipped with a Power Adapter to convert 100~240VAC@50-
60Hz to 5VDC. Connect the DC Output Cable from the Power Adapter to the
back of the unit and then plug the Power Adapter into an AC Receptacle. The
AVT-3350 has no power switch. As soon as the Power Adaptor is connected, the
unit will receive power.
5.0 OPERATING THE AVT-3350
The AVT-3350 can output either PC type signals or HD component type signals
however you must set the MODE switch correctly to ensure the AVT-3350 will
operate properly. If you are using a PC monitor, place the MODE switch in the
PC position. If you are using a component HD television, place the switch in the
HD position. This is necessary because the two signal types do not have the
same timing sequences.
Note: some component HD televisions have an HD-15 connector for the input
whereas others have three RCA type connectors for the inputs. If your
component HD television has RCA connectors, you will need to purchase an HD-
15 to Component adapter.
Next, if you have connected a Composite Video signal to the AVT-3350, press
the input switch on the top of the unit until the LED indicator turns Yellow. If you
have connected an S-Video (Y/C) signal, press the input switch until the LED
Summary of Contents for AVT-3350
Page 1: ...AVT 3350 Analog Video to PC HD Scaler Instruction Manual...
Page 2: ......