Page
11
of
54
Pendant Mount
For a proper pendant mount installation, the AV-PMJB-W pendant mount and SO-CAP-W mount cap are
required (sold separately). A pendant mount should only be attached onto hard ceilings including wood,
plastic, metal, and concrete.
1.
Using the mounting template, prepare the mounting provisions for the camera installation.
2.
Connect top shield, pendant pole and mount together as shown in Figure 1.
Figure 1: Attach the mount cap and pendant mount
NOTE: The thread size of top shield, pendant pole and mount is 1.5” NPT.
3.
Attach the pendant mount to the ceiling using the four wood screws provided or any optional
hardware suitable for the mounting surface.
4.
Run the Ethernet Cable and outside power cable (if necessary) through the supplied rubber
gasket and then through the pendant. Ensure the gasket is seated properly.
Figure 2: Attach the camera to the SO-CAP-W with the supplied screws
5.
To configure the camera, reference the camera discovery, set-up and configuration section.
