Auvidea X221D, Reference Manual

Page: 17 / 40

X221D & X221D-AI TECHNICAL REFERENCE MANUAL
VERSION: 0.3 Page 17 of 40 AUG.2022
34 GND
35 I2C_GP2_DAT_LVS ???
36 I2C_GP2_CLK_LVS ???
37 PEX_L0_CRQ_N E11
38 VDD_3V3 3.3V
39
VDD_3V3 3.3V
40
VDD_3V3 3.3V
5.18 J22 – ETHERNET
Standard pinout.
5.19 J24 – CSI-1
Pin Description Socket pin Note
1 VDD 3.3V (5V see instructions)
2 FT-SDA Connected to FT_SDA or I2C_GP5_DAT depending on
configuration (what is standard?)
3 FT-SCL Connected to FT_SCL or I2C_GP5_CLK (gibt kein
GP5!!!)depending on configuration
4 GND
5 CAM2_PWDN F57 Can be controlled with PWM01_40Pin (GPIO_07, socket pin
F57), default configuration is high, open drain output with
pullup 2.2k to 3.3V, this also connects to CAM1_PWDN
6 CAM2—MCLK Connected to J28 CAM LED pin 3
7 GND
8 CSI_1_D1_P J41
9 CSI_1_D1_N J42
10 GND
11 CSI_1_D0_P G41
12 CSI_1_D0_N G42
13 GND
14 CSI_0_CLK_P F43
15 CSI_0_CLK_N F42
16 GND
17 CSI_1_D1_P E39
18 CSI_1_D1_N E38
19 GND
20 CSI_0_D0_P E42
21 CSI_0_D0_N E41
22 GND
Per special request Auvidea can manufacture the board with CAM1_PWDN and CAM2_PWDN with
pullup to 1.8V.
CSI default voltage is 3.3V but it can be changed to 5V. To perform this modification, you need to
move the bead from the 3.3V location (marked with the number 3 as shown in the picture) to the 5V
location (marked with the number 5 as shown in the picture).
The same process applies to I2C where you must move two beads to the desired location of 1.8
(1.8V) or 3.3 (3.3V).