109
12.5 Group Zone Configuration
This function is available only from the advanced configurator level –
Basic Configuration
–
Configuration Mode
–
Advanced
.
It is used to combine any predefined speaker lines / zones into one. A group created in this way has the same functionalities in
the system as a single zone.
In order to create a new group, the following must be done:
1
Using the icon
, a new group is created whose generic name is ZoneGroup0000x; the name is editable by moving the
mouse cursor over it and pressing the left mouse button.
2
From the
Group and Areas
tab, the column on the right hand side of the screen, move the mouse cursor over available
Subzones
,
Zones
and add elements to the group by double-clicking of the left mouse button.
3
It is also possible to add all available subzones and zones by means of the dedicated icon
.
4
Group cloning function: Clone Group
– this is available under the icon
. Highlight the previously created group by
moving the mouse cursor over its name and by clicking the left mouse button once. Then select the icon
.
Clone group
results in creating a new group of the identical composition as the source group.
5
Group element graphic view: Preview Group
– this is available from the icon
. This function presents, in a graphic form,
in one table, all groups which have been created, as well as their members.
Summary of Contents for AutroVoice miniVES 2001
